標題:
為什麼電腦新裝上CD盤後不能順利開機?
電腦裝上新的CD盤後，每次開機都不能進入Window系統，每次都需按F1重新設定時間後才可進入，但設定後關機再開也出現同一問題! 請問是否安裝新硬件時出錯?
最佳解答:
If after power off you need to go in to bios to reset time then Take a look at the battery on the MB la if the clock need reset every time usually this problem. Also you can Manual set the IDE port to CD as well. Did you touch other jumper on the Mother board? Also sometime static on your hand may have damage the bios doring installation.
其他解答:
多數這個情況我見過好多次,多數係因為硬件有問題,令window不能正常啟動,多數第一次入左window之後就輕機,之後就入唔到,所以只好換果個新的,如果唔係一路都用唔到100%係咁|||||電腦入邊已經有磁磚or cd等...(已關機狀態) 都係唔可以正常咁開機架.. 放碟再開機呢d手法...多數都係用黎整電腦內部的..... 例如洗機碟... 要放碟關機再開機黎啟動隻洗機碟的~ 2006-11-16 14:08:20 補充： 磁磚=磁碟..sor
為什麼電腦新裝上CD盤後不能順利開機?
此文章來自奇摩知識+如有不便請留言告知
發問:電腦裝上新的CD盤後，每次開機都不能進入Window系統，每次都需按F1重新設定時間後才可進入，但設定後關機再開也出現同一問題! 請問是否安裝新硬件時出錯?
最佳解答:
If after power off you need to go in to bios to reset time then Take a look at the battery on the MB la if the clock need reset every time usually this problem. Also you can Manual set the IDE port to CD as well. Did you touch other jumper on the Mother board? Also sometime static on your hand may have damage the bios doring installation.
其他解答:
多數這個情況我見過好多次,多數係因為硬件有問題,令window不能正常啟動,多數第一次入左window之後就輕機,之後就入唔到,所以只好換果個新的,如果唔係一路都用唔到100%係咁|||||電腦入邊已經有磁磚or cd等...(已關機狀態) 都係唔可以正常咁開機架.. 放碟再開機呢d手法...多數都係用黎整電腦內部的..... 例如洗機碟... 要放碟關機再開機黎啟動隻洗機碟的~ 2006-11-16 14:08:20 補充： 磁磚=磁碟..sor
文章標籤
全站熱搜
留言列表
